240SX Rear Interior Panels for the S13 Hatch (Steel Trim Replacement)

Bare steel rear interior panel installed in a 240SX S13 hatch

The rear interior trim in a 240SX S13 hatch is over 30 years old now. On most cars it's cracked, faded, missing clips, or gone completely after someone gutted the interior. Finding good used panels gets harder every year, and the ones you do find are the same age as yours.

I made a steel replacement. It works two ways: as a clean cosmetic panel in place of the old plastic, or as a solid surface to mount things on.

Option 1: Replace cracked or missing rear trim

If your rear trim is cracked or missing, or you've stripped the interior for a drift or track build, these panels close up the rear side area so the hatch looks finished instead of gutted. You don't need to hunt down old OEM plastic.

Steel rear interior panel installed in a 240SX S13 hatch

They ship as bare steel, so you can paint them or have them powder coated to match your build.

Option 2: Use it as a mounting surface

Steel is a lot stronger than plastic trim, so the panel can hold real parts. In my car, I painted mine green and mounted a 100A circuit breaker on it.

240SX S13 rear interior panel painted green with a 100A circuit breaker

The breaker is just one example. Other things you could mount:

  • a circuit breaker or kill switch
  • a fuse block or relays
  • switches
  • wiring, tied down so it isn't loose in the hatch

Mounting your ECU, relays or fuse block up front instead? See where to mount the ECU in a 240SX S13.

What's included

  • A pair: one left panel and one right panel
  • Finish: bare steel, ready to paint or powder coat
  • Not included: the mounting hardware (rivnuts and bolts), paint, and anything you mount to the panel

How to install 240SX rear interior panels

  1. Remove the old rear trim if it's still in the car.
  2. Test fit each panel and mark where you want it to mount.
  3. Drill and install rivnuts at your mounting points.
  4. Paint the panels if you want, before final install.
  5. Bolt the panels in.
  6. Mount your parts if you're using it as a mounting surface.

Time: about 1–2 hours for both sides.

Before you drill: check behind the panel area for wiring, fuel lines and anything else you don't want to hit.

Things to know before you buy

  • Fit: made for the Nissan 240SX S13 hatchback (1989–1994).
  • Drilling required: the panels mount with rivnuts, so you'll need to drill.
  • Fit can vary with your interior condition, trim, roll cage, rear seat setup and past modifications.
  • Made to order: ships within 7 business days.

Get a set

šŸ‘‰ 240SX S13 Hatch Rear Interior Panels, $139.99

FAQ

Do they fit coupes or convertibles?
No. They're made for the S13 hatchback.

Do I need to paint them?
No, but most people will. They ship as bare steel, so paint or powder coat them before installing.