Where to Mount the ECU in a 240SX S13 (Clean Glove Box Setup)

240SX S13 glove box plate installed under the dash vent

If you've swapped an SR20DET into your S13, or you're running a standalone ECU, you've probably hit the same question: where does the ECU actually go? On a lot of 240SXs, the answer ends up being "zip-tied somewhere behind the glove box," with the wiring hanging down by the passenger's feet.

There's a cleaner way to do it. Here's the setup I use in my S13.

Why mount the ECU in the glove box area

On most S13 builds, swap and standalone ECUs end up on the passenger side behind the glove box. There's room there, and it keeps the ECU inside the car, away from engine bay heat and water.

The problem is that the space behind the glove box was never meant to hold:

  • a swap ECU that's a different size than the stock one
  • relays, a fuse block or a power distribution module
  • extra wiring from gauges, fans or a fuel pump rewire

So it usually turns into a mess.

The fix: a flat metal mounting plate in the glove box opening

I made a bolt-on plate that replaces the glove box and gives you a flat metal mounting surface for your electronics. You mount everything to the plate instead of hanging it in the dash.

240SX S13 glove box plate installed in place of the glove box

What you can mount to it:

  • ECU: an SR20DET swap ECU or a standalone ECU
  • Relay panel
  • Fuse block
  • Power distribution module
  • Wiring: tuck it and tie it down so it isn't hanging loose

My setup: SR20 ECU on the plate

In my car, the ECU sits on my SR20DET ECU Mount, which is bolted to the plate. The ECU is held solid, the harness comes in neatly from the top, and I can still reach it for tuning or troubleshooting.

SR20DET ECU mounted to the 240SX glove box plate

How to install the 240SX glove box ECU plate

  1. Disconnect the battery before you touch any ECU wiring.
  2. Remove the glove box.
  3. Plan your layout before drilling. Set the ECU, relays and fuse block on the plate and check that the harness reaches without stretching.
  4. Mount your electronics to the plate. Depending on your parts, you may need to drill your own holes.
  5. Bolt the plate in at the factory glove box mounting points, using the stock hardware. No drilling in the dash.
  6. Tidy the wiring, reconnect the battery, and check everything powers up.

Time: about an hour, including laying out and mounting your ECU and relays on the plate.

Running a breaker, relays or a relocated battery in the hatch too? The 240SX rear interior panels give you a steel mounting surface back there.

Things to know before you buy

  • Not included: the ECU, ECU mount, relay panel, fuse block and wiring.
  • No dash drilling: the plate bolts to the factory glove box mounting points. You may need to drill the plate itself to mount your specific ECU or relays.
  • The glove box goes away: this plate takes the glove box's place, so you trade the storage for a clean electronics panel.
  • Fit: made for the Nissan 240SX S13 (1989–1994).

Get one

240SX Glove Box Plate / ECU Mounting Cover, $89.99
SR20DET ECU Mount, $49.99

FAQ

Will it work with a standalone ECU?
Yes. It's just a flat mounting surface, so a standalone ECU mounts the same way. You may need to drill holes to match your ECU.

Can I still get to the ECU for tuning?
Yes. It's mounted right in the glove box opening, so it's easy to reach.